No. 7 HHO Cook University On YouTube.

This is a new configuration of the box with the same dish arrangement.I wire rose to # 6 stranded copper.I 5 / 16 brass screws and brass nuts and washers used the electrical contact points on the inside of the stainless- conductors and the outside of the copper wire terminals.I put a 4.1-inch diameter galvanized steel washers between the 16/05 split-ring washers to act as cooling fins.I changed the flat steel link tracks brass bolts on the electricalThe 1 / 2 inch wide strips to a much thicker and about one centimeter strip before stainless.After here to see the water temperature at about 170 degrees F. was dismantled and I found the pieces to heat damage to plate hdpe inspected home-made on the negative terminal of the inner conductor housing.This is much shorter than the corresponding positive lead to positive and I think the band benefited from the cooled solution.I also be noted that the solutionturned red from what I believe is from the iron plates, production time by increasing the size of the flame and the temperature of the solution temperature.The climbing probably also increases the gas efficiency.